MB20 Granite Polish

MB-20 Granite Polish is a professional-grade granite polishing powder designed to restore shine and clarity to granite, engineered stone and serpentine surfaces. Ideal for both countertops and floors, it delivers a high-gloss finish with minimal effort.

Available in  8.5oz sizes.

Approximate coverage for one  8.5oz tub is 100-200 sq ft.

Once the pad becomes saturated, the coverage increases

Directions:

Countertops:

• Always make sure proper masking of the work area is utilized to protect surfaces that could be splattered by product.
• Wear safety glasses and gloves.
• Make sure the surface is free of any coatings, waxes, sealers, grease and/or soil.
• If the surface requires honing, use quality diamond pads and hone surface to at least 1000 grit or higher predicated upon the clarity of the stone.
• With your variable speed right angle grinder (a must have) attach a pad driver and a hogs hair pad and set the speed to mid-range.
• Use about a ½ teaspoon per sq ft (remember the amounts will vary) of product and a small amount of water (1/2 tablespoon).
• Target a 2 sq ft area and place the product in the centre of your surface.
• Place your machine and white pad directly on top of the product and water.
• Starting slowly, spread the product out controlling the trigger while applying pressure attempting to dry out the product.
• As the product dries, increase the speed, while moving the machine swiftly over the targeted area.
• The use of pressure will vary depending on the stone but generally some pressure can be applied.
• Check your results and repeat if needed.
• Remove any streaks or swirl marks using a white pad with a mist of water.
• Adjust the amount of product you are using and continue.

Floors:

• Always make sure proper masking of the work area is utilized to protect surfaces that could be splattered by product.
• Wear safety glasses and gloves.
• Make sure the surface is free of any coatings, waxes, sealers, grease and/or soil.
• If the surface requires honing, use quality diamond pads and hone surface to at least 1000 grit or higher predicated upon the clarity of the stone.
• Target an area of approximately 8-10 sq ft
• Place product in the centre of your target area using 2 tbsp of product, spray with enough water to wet the product so you get a semi-thick slurry that will not produce splatter.
• Place your floor machine with a white pad pad on top off the product and begin to spread it out over your target area.
• Work the product until the slurry dries out and the stone becomes polished.
• The pad should be flipped over every 50 to 75 sq ft
• A floor machine with a strong motor over 1.5 HP and weight of about 135 lbs. will perform and produce the best results.

These Directions are a base line guide to using this product as it may require different techniques for different stones. If in doubt don’t hesitate to contact us.